BETAFPV GoPro BEC Board for Hero 8

To provide more choice for our customers, BETAFPV  designed a new BEC board for GoPro HERO8. This BEC board only weighs about 1.5g, which makes your naked GoPro super neat and light. This BEC Board has integrated 5V@2A BEC, stock GoPro buttons, and LED pluggable connectors and remote recording. You don’t need to worry about your GoPro turning off during a flight anymore.

Note: The BEC board for HERO8 does not fit the Case V2.

FEATURES

• BEC Board is specially designed for Naked GoPro HERO6/7/8 which weighs about 1.5g, makes your naked GoPro lighter and easy to install on your drone.
• The BEC output voltage is 5V@2A, avoid the accident of power of which is caused by the insufficient power supply for the FC board. Also, stock buttons and LEDs are integrated.
• Integrated GoPro stock buttons, Power/Mode Button, and Record Button.
• Integrated GoPro stock LED to know the status of the camera.
• The pad is available for pilots to control the GoPro recording via the radio transmitter.
• With the pluggable connector, which is easier to connect with your flight controller for power supply and recording.

SPECIFICATION

• Item: BEC Board for Naked Camera
• Weight: 1.53g/1.57g
• Output: 5V @ 2A
• Input voltage: 2-4S
• Connector: GH 1.25 3P connector

BEC BOARD DIAGRAM

The two buttons on the BEC board have the same functions as the GoPro spare buttons. Three actions we will use frequently.

• Power on-Press the power/mode button, the LED flashes three times and goes out.
• Start recording-Press the “Record” button once and the LED flashes slowly. If the LED flashes once and goes off, it means there is no SD card.
• Stop recording-Press the “Record” button, the LED stops blinking slowly.

INCLUDES

• 1 x GH1.25 Power Cable (80mm 30AWG)